Eng | 中
FLASHFORGE
  • Home
  • Products
    • Adventurer 3
    • Adventurer 4
    • Creator Pro 2
    • Creator 3 Pro
    • Creator 4
    • Guider IIs
    • Guider 3
    • Guider 3 Plus
    • Foto 9.25
    • Foto 13.3
    • Hunter
    • WaxJet 400
  • Materials
  • Support
  • Blog
  • Contact Us
  • Home
  • Products
    • Adventurer 3
    • Adventurer 4
    • Creator Pro 2
    • Creator 3 Pro
    • Creator 4
    • Guider IIs
    • Guider 3
    • Guider 3 Plus
    • Foto 9.25
    • Foto 13.3
    • Hunter
    • WaxJet 400
  • Materials
  • Support
  • Blog
  • Contact Us

Detailed settings of a treelike support in 3D slicing software 

26/11/2016

 
Picture
Previously we introduced the difference between treelike support and linear support in the 3D slicing software. Today we are going to talk about the detailed settings of treelike support. 
​

There are several settings available for Treelike support in the Flashforge's 3D slicing software Flashprint, which are as followings:
Picture
1. Overhang Thresh
Treelike support will be added when the overhang angle of the 3D model is bigger than the angle you type in the Overhang Thresh field. ​
2. Post Diameter
This is to set the diameter of the treelike support for the 3D model, bigger diameter is better if the treelike support it very long, otherwise it may be broken during the 3D printing process.
3. Base Diameter
Picture
This is the to set the diameter of the bottom part of the treelike support. Sometimes the treelike support may fall down or can not attach to the build plate of the 3D printer firmly because of the small base diameter. Increasing the base diameter can improve the situation when 3D printing.
4. Base Height
Picture
​It refers to the height of the base of the treelike support. If the treelike support is long, longer base height is better as it will provide a stronger structure.
Other article
Picture



​Add/ Remove support material in the 3D slicing software
Thomas
10/8/2020 03:22:23

You should include what you recommend the post diameter be set to for varying heights so the end use (me) doesn't have to go through the trial an error process of finding out what works.


Comments are closed.

    Blog

    Archives

    June 2022
    November 2016
    October 2016
    September 2016
    February 2016
    October 2015
    August 2015
    June 2015

    Categories

    All
    3D Slicing Software Settings

    RSS Feed

Products

Adventurer 3
​Adventurer 4
Creator Pro 2
​Creator 3
Creator 3 Pro
Creator 4​
Guider IIs
Foto 8.9
Foto 13.3
Hunter

​WaxJet 400

Support

Warranties
Course Booking

Flashforge

Contact Us
​Blog

English  中
 © COPYRIGHT 2022. ALL RIGHTS RESERVED.